PRG Best Boy Wash User Manual - Manual (Page 30)

22 BEST BOY ® WASH LUMINAIRE USER MANUAL
POWER UP AND BASIC SETUP PROCEDURES
Powering Up the Luminaire
When AC power is applied, the luminaire will begin a calibration sequence which moves its pan, tilt, and all beam
control mechanisms. After calibration, the luminaire head will either stop at its "home" position (which positions the
pan axis at mid-rotation and the head parallel to the yoke with the lens pointing away from the luminaire upper
enclosure) or move to its current DMX-defined position if DMX512 data is present. The beam control mechanisms will
also move to their "home" or DMX-defined positions. The lamp is set to OFF in the default mode.
The luminaire also contains an on-board battery so that it can be addressed and configured without being connected
to main power (refer to
"Wake Switch" on page 30).
CAUTION: Before applying power, be sure the luminaire is hung or positioned so that the head and yoke can
move freely without restriction. Refer to clearances in Figure 2-6 on page 16 .
To power up:
Step 1. At each luminaire, connect power. Allow luminaire to complete its calibration sequence.
Step 2. For normal power up, the Menu Touchscreen "Home" screen will display Status OK. The Home screen will
also display the luminaire’s DMX address and lamp information.
Step 3. Check Comm LED for proper operation. Refer to "Comm LED Operation" on page 23.
Step 4. To strike lamp, send appropriate command from console or follow steps provided in "Starting the Lamp" on
page 26.
Figure 2-12: Menu Touchscreen at Power Up
Note: Refer to "Menu System" on page 30 for more information about the Menu Touchscreen.
Home Screen