Potter PFC-5000 Series - Manual (Page 21)

17
UDACT / DACT (UDACT-9100) Terminal Connections
The following diagram shows the wiring connection for the UDACT-9100, refer to LT-888POT for more details.
Wire the two telephone lines to RJ31X Connector terminals as shown in Figure 14 below. The UDACT-9100 terminals are
located on the top left hand corner of the board. If using a cellular or wireless service, use the Line interface connection only.
Note:
Most AHJs do not allow the connection of premise telephones. See Wiring Tables on page 20 and Appendix C page 37 for
more information.
Figure 14: UDACT-9100 Wiring Diagram
UDACT-9100