Philips TSU3000 - Manual (Page 31)

Using the Power Features
User Guide
To add an action to the action list
0Tap GiD in the 'Macro' screen.
The last visited page appears again.
[I Navigate to the Device and the Page that contains the button you want
to add to the macro.
Tap the button you want to add to the macro.
The 'Macro' screen appears.
The action of the selected button is added at the bottom of the Action List.
[G You can select other buttons to add to the macro.
To add a delay to the action list
You can add a delay to the action list e.g. to insert a short pause between turning
on a device and sending commands to it, allowing the device to warm up.
[j] Tap in the'Macro'screen.
The'+' button and'-' button appear on the two middle hard buttons below the
touch screen.
[G To increase the delay, tap (and hold) the '+' button.
-or­
To decrease the delay, tap (and hold) the '-' button.
To add a beep to the action list
To determine when the macro execution is finished, it is useful to add a beep as
final command in the action list.
[G Select the action in the action list, where you want to add a beep.
The action is selected.
[G Tap in the'Macro'screen.
A default beep is added to the action list, after the selected action.
To finish the macro
rn Tap in the'Macro'screen.
The macro is created and assign to the button you selected as a target.
[T| Press the left hard button i below the touch screen to exit the
Macro Tool.
31