Oakworks Spine Positioning System - Manual (Page 10)

preparation for use
Unpack and inspect all components. Identify the components and their use with the pictures located in the
Description Section of these instructions.
All components are shipped in a clean but not sterile condition. If the Spinal Imaging Platform will be used for
an indicated surgical procedure, be sure to disinfect the components prior to use. Disinfectants that can be used
are described in the Cleaning & Disinfecting Section of these instructions.
CAUTION - Do not overhang the platform frame beyond the warning line on the frame.
WARNING - A patient saftey strap is recommended during all procedures. A patient saftey strap must be used
during procedures where lateral roll function is used.
d
ire
CT
ions
for
use
8
directions for use
face rest platform adjustment
Step 1 - open cam Step 2 - Grasp platform and raise to
desired position
Step 3 - Begin to close cam making
sure that the small locking pins enter
corresponding positioning holes
(Minor platform “rocking” may be
necessary for the pins to enter the
holes). The cam should move freely
at this point (Do not force the cam)
Step 4 - Continue to close cam. Step 4 - Force will increase as cam
is near final position. Close cam to
the final position
Step 5 - Double check platform by
applying downward force (platform
will easily support over 80 lbs.).
Your face rest platform is now
securely locked.