beautypg.com

Oakworks Paper Roll Holder User Manual

Oakworks, Paper roll holder

background image

Snap buttons on insertion

rods secure the unit

to the table.

Independent snap button adjustments on

the paper roll arm accommodate paper sizes

from 18” to 32” in width.

The Professional’s Choice

Fig. 1

Fig. 2

Fig. 4

Instructions for Installation:

OAKWORKS

®

Paper Roll Holder

Toll Free Phone: 800-558-8850 Phone: 717-235-6807

Toll Free FAX: 877-562-4787 FAX: 717-235-6798

www.oakworks.com

OAKWORKS

®

, Inc.

923 East Wellspring Rd., New Freedom, PA 17349

Fig. 3

Elastic strap holds the paper down

Elastic strap

Part no. 6487 Rev. 8.2.13

1. Hold the snap buttons in (Fig 1) and insert the rods into the

outlets at either end of the table. (Fig .2)

2. Use the smaller snap buttons on the paper roll arm to adjust it

for the accomodation of paper rolls from 18” to 32” in width.

(Fig.1)


3. To remove the unit from the table, push in on the snap

buttons from underneath the table and pull the insertion

rods out.

4. The tough powder coated finish makes cleaning easy: just wipe

with a soft cloth or sponge and mild soapy water.

Instructions for Attaching & Using the Elastic Strap

This Elastic Strap holds your paper down close to the table at the

opposite end from the Paper Roll Holder.

5. The length of elastic included with your Paper Roll Holder is

stitched in a continuous loop, like a giant rubber band. Simply

slide this elastic band over the end of the table opposite to the

end on which you installed the Paper Roll Holder.

6. Pull a length of paper from the Paper Roll Holder, across the

top of the table and tuck the paper underneath the elastic.

(Fig.3).

7. Your table is now protected and ready for your client. (Fig. 4)