Oakworks Attaching Bolster Arm Rest - Manual

Toll Free Phone: 800-558-8850 Phone: 717-235-6807
Toll Free FAX: 877-562-4787 FAX: 717-235-6798
www.oakworks.com
Part no. 6491, rev. 0205
Parts Included:
Tools Needed:
(not included)
Pencil
Ruler
1 - set of Bolster
Arm Rests
1 - set of Bolster
Arm Rest Straps
8 - Velcro Strips
• Turn table upside down.
• Remove paper backing from velcro strips and place velcro strips
carefully on the inside of each side rail at points 8 1 / 2 " and 23
1 / 2 " from the hinge rail, adhesive side down. (Fig. 1) Make sure
the velcro is contacting only wood and press into place.
Note: If you install the velcro on the inside of the table frame,
you should wait 24 hrs before use.
Set-up Instructions:
• Turn table upright and place the straps across the table. (Fig.2)
• Attach straps to the velcro strips on the inside of the side rail.
(Fig 3)
• Attach the Bolster Arm Rests to the table by attaching the velcro
tabs on the bolsters to the velcro on the table straps. (Fig 4 & 4a)
Other Uses for Your Bolster Arm Rests:
• Detach your Bolsters from the straps and use them to provide
support under knees and ankles.
• Your new Bolster Arm Rests will comfortably cradle your client’s
arms and effectively widen your table by 6".
• The standard strap is long enough to fit tables 24"-31" wide.
Tables that are 33" wide require a special, longer strap. Contact
Customer Service for information on this option.
WA R N I N G
Your Bolster Arm Rests are only meant to support client’s
arms when they are lying supine or prone. They are not
meant to support clients getting on or off the table or
therapists sitting on the edge of the table.
Fig. 1
Fig. 4a
Fig. 3 Fig. 2
Fig. 4
Instructions for Installation
(not applicable if ordered with a table):
Bolster Arm Rest Installation Instructions
O AKWORKS ® , Inc.
923 East Wellspring Rd., New Freedom, PA 17349
Side Rail
Velcro Strips
Velcro on Bolsters
Hinge Rail
23 1 / 2 "
8 1 / 2 "
Velcro
on
Straps