Oakworks Wellspring Setup - Manual

Wellspring
™
, Advanta
™
, Alliance
™
Metal, Storable Mat
Dynamic Load Rating:
550 lbs.
CAUTION
OAKWORKS
®
, Inc.
923 East Wellspring Rd., New Freedom, PA 17349
Toll Free Phone: 800-558-8850
Phone: 717-235-6807 FAX: 717-235-6798
www.oakworks.com
Part No. MMINWC0004 - Wellspring, Advanta, Alliance Metal, Storable Mat Rev. 0308
All portable tables: U.S. Patent 5,009,170
Unilock™ Patent Pending
Integra Hinge™ U.S. Patent 5,943,965
CS System: U.S. Patent 6,192,809
O
riginal
akworks ®
Made in the U.S.A.
with U.S. & Imported Parts
Inspected By:
Fig. 1
To Set-up the Table:
• Place the folded table sitting on
the rubber bumpers; with the heel
of your hand, bump the UniLock™
tab between the face rest outlets
and the table will open. (Fig. 1)
• Open the table part way, making
sure the cables are still slack
(Fig. 2)
• Press the “Y” brace against the
table, then pull up on the legs
one at a time. (Fig. 3) Do the same
on the other end. Open the table
until the leg braces and table top
are completely extended and
unwrap any cables that may be
caught in the legs.
To Set the Table Upright:
• When the table is fully opened, tilt
the table upright until all four feet
are on the floor. Lift one end of the
table, press down on the middle and
tension the cables a little. (Fig. 4)
To Close the Table:
• Turn the table on its side with the
rubber bumpers down. If you own
a face-rest, store it under the table
(Fig. 5). Partially close the table top.
• Fold the legs into the table and
make sure the cables are inside of
the table. Push the two halves of
your table together to lock. (Fig. 6).
Note: Advanta leg extensions must
be fully retracted to close the table.
To Change the Table Height:
• With no weight on the table, press
the button on the leg and rotate the
leg extension slightly to take the
button out of alignment with the
holes, but still within sight. Adjust
all extensions to the desired height
and turn until the button pops out
of the aligned hole. (Fig. 6)
NOTE: O
akwOrks ®
is not liable for injuries or damages
sustained when table is not used in the manner prescribed.
• To open/adjust - Release velcro tab
located under the center end of the
table and pull up. Raise the center of
the backrest, stopping at desired height
• Make sure that both sides of the
tilting hardware are on the same
setting and are both locked in place.
Backrest
• To close, raise the backrest fully and lower to
closed position. Re-attach velcro tab to hold
backrest in closed position. Refer to warning
on under side of table for precautions.
Fig. 2
Fig. 6
Fig. 4
Fig. 6
Fig. 3
Fig. 5