Installation complete – Neuspeed 65.10.80 User Manual
Page 2
NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •
• Visit us on the web…
http://www.neuspeed.com
9.
Install air box inlet adapter to stainless steel bracket using
(2) bolts and (2) lock nuts supplied.
10. Insert air box inlet adapter into silicone hose, and then push
down stainless steel bracket onto pin mount just in front of
the battery. Adjust bracket as necessary and make sure
silicone hose is fully seated.
11. Tighten both silicone hose clamps now.
12. Wipe inside of filter mounting flange to remove any filter oil
residue and install air filter. NOTE: Re-check tightness of
air filter mounting clamp after one week.
13. Install rubber weather seal on top edge of stainless steel
bracket.
14. To reinstall factory engine cover, remove air intake duct
using spring clamp pliers. Cover air inlet and outlet holes
with duct tape.
15. Double check complete installation and tightness of all
connections.
INSTALLATION COMPLETE
©2008, Automotive Performance Systems, Inc. All rights reserved. Reproduction in whole or in part is prohibited.
DOC.65.10.80 Rev. 9.03.10