Neuspeed 65.10.64 - Manual (Page 2)

NEUSPEED • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX
www.neuspeed.com
4. Due to slight variations in vehicle geometry (see
illustration above), it is necessary to drill the radiator
support to properly mount the heat shield. Pull the heat
shield forward (towards the front of the car) until the
mounting tab contacts the radiator support. Using the
front mounting tab hole (slotted) as a guide, mark and
center punch the radiator support.
5. Remove the head shield and drill a

¼” hole
through the radiator support.
6. Install the heat shield and secure in front with the
supplied push fastener and at the side with the supplied
sheet metal screw as shown.
7. Mount mass air sensor to heat shield using supplied
¼” bolts and lock nuts. Install air filter on mass air
sensor and tighten hose clamp. NOTE: Check
tightness of clamp in one week.
8. Carefully double-check complete installation. TEST
DRIVE CAREFULLY.
©Copyright 2002, NEUSPEED ® . All rights reserved. Reproduction in whole or in part prohibited.
DOC.65.10.60 Rev. 08.14.02