Finished installation – Neuspeed 65.10.97 User Manual

Page 2

NEUSPEED® • 3300 Corte Malpaso • Camarillo, CA 93012 • 805.388.7171 • 805.388.0030 FAX •

• Visit us on the web…

http://www.neuspeed.com

9. Install NEUSPEED intake pipe onto turbo

inlet with #40 clamp supplied and
attach rubber isolator mount to ear on

end of cylinder head with M6x10mm

screw. Intake pipe should be positioned

at an upward angle toward brake fluid

reservoir for engine torque clearance,

now tighten hose clamp and M6 screw.

NOTE: When tightening isolator

mount, do not over tighten – rubber

isolator should not have any

twisting force applied to it.

10. Install MAF sensor (fits one direction

only) and tighten with two M4x8mm

Philips head screws supplied. Attach

electrical connector.

11. Install filter onto end of intake pipe.

12. Double check installation and tightness

of all connections. PLEASE TEST DRIVE

CAREFULLY.

FINISHED INSTALLATION

This manual is related to the following products: