beautypg.com

Unpacking, Re-packing for shipment – MF Digital Spectrum 2 Thermal (Rev: 03/05/01) User Manual

Page 10

background image

Spectrum2 Printer Operator’s Guide

Document Revision: 100102

9

Unpacking

Open the top of the box

Lift the Spectrum2 by gripping the underside of the narrow sides of the unit

Set the Spectrum2 and foam on a sturdy, flat surface

Support either end of the Spectrum2 with an arm and carefully pull the foam off the

elevated end. Repeat for the shipping foam on the other end

Note:

Printer is shipped with black ribbon installed

Printer is shipped with top cover secured by plastic wrap or tape

Re-packing for shipment

Important: Make sure Printer Chassis is locked. Check by lifting the chassis up. The

chassis should not move. To re-lock, pull Chassis Lock Knob out, then release and
check by lifting chassis. When locked the chassis will not open. (See Parts
Identification section for location of Chassis Lock Knob)

When re-packing for shipment, secure outer top cover by plastic wrap or tape before

placing printer into foam pieces.