Leitz VariPlan Plus - Manual (Page 16)

D
eu
ts
ch
En
gl
is
h
日日
本本
語語
中
文
Ita
lia
no
Fr
an
ça
is
Es
pa
ño
l
Po
rt
ug
uê
s
Ру
сс
ки
й
16 04/2012 ID.524660 V1.0
Woodworking tools and clamping devices are to be protected against humidity in order to
avoid corrosion. Adequate detergents and care products: multi-purpose oil, e.g. WD 40 or
Ballistol
1.6 Servicing, modifying, sharpening
1.6.1 General instructions
Service and modifications are only allowed to be done by the manufacturer or by
authorized professional workshops.
Danger of tool breakage.
Only those replacement parts are allowed to be used, which match the requirements of
the original replacement parts of the tool manufacturer.
Tolerances, that guarantee a precise clamping, have to be kept.
Sharpening, repairing or modifying of tools is only allowed to be done by experienced
specialists as per the instructions of the manufacturer.
Specialists must have knowledge and experience of:
- up-to-date engineering standards in the design and construction of woodworking tools
- national rules and regulations
- relevant safety regulations and standards
- and have the necessary machinery and the required skills to undertake the task
After any sharpening, repairing or modifying, it shall be guaranteed, that the tool meets the
requirements of the European Standard EN 847-1, especially regarding: