KERN & SOHN SFB 300K-1LM - Manual (Page 45)

SFB-BA-e-1324 45
8.2 Overview verified models
In verified weighing systems the access to „P2 mode and „P4 tAr“ is locked.
In order to unlock the access, the seal must be destroyed and both contacts of the
printed circuit board [K2] must be short-circuited by a jumper, see chap. 6.11.
Attention:
After destruction of the seal the weighing system must be re-verified by an
authorised agency and a new verification wire/seal mark fitted before it can be
reused for applications subject to verification.
Menu block
Main menu Menu item
Submenu
Available settings / explanation
PO CHK
Weighing with
tolerance range,
see chap. 7.7
SET H Upper limit value „Tolerance check weighing“, input see chap. 7.7.1
SET LO Lower limit value „Tolerance check weighing“, input see chap. 7.7.1
PCS H
Upper limit value „Tolerance check counting“, input see chap. 7.7.2
PCS L
Lower limit value „Tolerance check counting“, input see chap. 7.7.2
BEEP no
Acoustic signal for weighing with tolerance
range switched off
ok
Audio sound when load is within tolerance
limits
ng
Audio sound when load is beyond tolerance
limits
P1 COM
Interface
parameter
MODE CONT Continuous data output
ST1 One output for stable weighing value
STC Continuous data output of stable weighing
values
PR1
Output after pressing
PR2 Manual totalizing, see chap. 7.8
Press and the weighing value will be
added to the summation memory and issued.
AUTO
For automatic totalizing see chap. 7.9. This
function is used to issue and add individual
weighing values automatically to the
summation memory on unloading of weighing
scale.
ASK For remote control commands, see chap. 10.4
wireless
Not documented
Kit 1
baud Available Baudrate: 600, 1200, 2400, 4800, 9600
Pr 7E1 7 bits, even parity
7o1 7 bits, odd parity
8n1 8 bits, no parity
PtYPE tPUP Standard printer setting
LP50 Not documented
Lab Lab x
Details see following table 1
Prt Prt x