Keri Systems V-Track - Manual (Page 7)

V-Track™ Automatic Long Range Vehicle ID System
Installation Guide
Page 7 of 20 P/N: 01538-001 Rev. G
Figure 6: Receiver PCB
Keri recommends the following cable gauges:
• AWG 22 allows up to 500 feet
• AWG 24 allows up to 200 feet
Wire the Receiver to the access panel per the appropriate diagram in Section 7.3.
NOTE: The cable seals in the body of the Receiver enclosure are designed to accommodate one cable. Forcing more than
one cable through these seals compromises the weather-tight seal, allowing water to enter the body of the enclosure.
Table 2: RXR-10 Receiver Electrical Requirements
Parameter Requirement
Power Supply Nominal DC Voltage 12.0 VDC
Voltage Range 11.0 VDC to 15.0 VDC
Nominal Current 100 mA
Recommended Power Supply 12 VDC @ 250 mA or greater, fully regulated,
- Receiver can be powered by the host controller’s
12 VDC supply
External
Antenna
Connector
Red LED
Green LED
Beeper
RV1
Range
Adjust
S1
Antenna
Ground
1
2
3
4
5
6
7 +12 VDC
Ground
Ground
Ch A Out/D0
Ch A/D1
Ch B Out/D0
Ch B/D1
A / Rx (Green Wire) B / Tx (White Wire)
S2
Grommet
(on enclosure
cover)
Grommet
(on enclosure
cover)
increase