Keri Systems V-Track - Manual (Page 6)

V-Track™ Automatic Long Range Vehicle ID System
Installation Guide
Page 6 of 20 P/N: 01538-001 Rev. G
3.0 RXR-10 Receiver Installation
The Receiver range pattern is omnidirectional, a large, circular shape with a radius of up to 100 feet (30M). A typical
mounting location is in a gatehouse for gated communities, or other enclosure, which makes it convenient to provide a
data cable from the Receiver to the control unit. An external antenna can be installed if the Receiver is mounted in a
difficult RF signal area. The LRT-5 Transponder sends its signal to the Receiver at 433 MHz so the detection pattern is
very similar to that of a garage door opener or the remote unlock on your automobile. Cable type and run length are like
any proximity reader and are specified below. The Receiver antenna detection pattern is shown in Figure 5.
Figure 5: RXR-10 Receiver Detection Pattern – 100 Foot Radius Circle
The PC Board outline for the RXR-10 Receiver is shown in Figure 6 on page 7. The Receiver is equipped with a Range
adjustment potentiometer (RV1). For single lane applications the system installer only needs to supply DC power to the
Receiver and Exciter. For information on Enter/Exit applications, please refer to Section 6.0 in this Installation Guide.
RXR-10 Receiver
Gatehouse or similar location
Up To 100 Feet
LRT-5
Transponder