Keri Systems V-Track - Manual (Page 4)

V-Track™ Automatic Long Range Vehicle ID System
Installation Guide
Page 4 of 20 P/N: 01538-001 Rev. G
2.2 Exciter Electrical Installation
The Exciter comes configured from the factory for single-lane or for dual-lane entrance/dual-lane exit applications.
Make wiring connections as follows:
• In single-lane applications only the Power (red) and Ground/Shield (black/silver) connections are made. Clip off the
unneeded Green and White wires.
• In dual-lane applications, connect the A-wire (green) to the LRT Receiver at J3 and connect the B-wire (white) to the
LRT Receiver at J3. Then connect the Power (red) and Ground/Shield (black/silver) wires.
• If the Arming Input is not being used, the Arming Input High (blue) and Arming Input Low (brown) wires MUST be
shorted.
Please refer to Section 6.0 in this Installation Guide for more information on Enter/Exit (two-lane) applications.
Figure 4: Exciter PCB
RF Antenna Cable
SHIELD
(connect to ground)
GND - BLACK
+12 VDC - RED A-wire - GREEN (to LRT Receiver, J3)
B-wire - WHITE (to LRT Receiver, J3)
not used in
single-lane
applications
EX-10
Exciter
Exciter
configuration
label
Mounting
Hardware
Exciter
Antenna
Power/Data
Cable
Arming Input Low - BROWN (to Arming Device)
Arming Input High - BLUE
(to Arming Device)