Crestron electronic TPS-GA-TPI - Manual (Page 9)

Crestron TPS-GA-TPI Isys ® G-Series Touchpanel Interface
TPS-GA-TPI Specifications (Continued)
SPECIFICATION DETAILS
Power Requirements
Cresnet Power Usage 32 Watts (1.34 Amps @ 24 Volts DC)
Default NET ID 03
Minimum 2-Series Control
System Update File
2, 3, 4
Version 3.155.1143 or later
Environmental
Temperature 50° to 113°F (10° to 45°C)
Humidity 10% to 90% RH (non-condensing)
Heat Dissipation 110 BTU/Hr
Enclosure
Chassis Steel, black matte powder coat finish,
vented top and sides
Faceplate Extruded aluminum, black matter powder
coat finish with polycarbonate label overlay
Mounting Freestanding or 1 U 19 inch rack mountable
(adhesive feet and rack ears included)
Dimensions
Height 1.80 in (4.57 cm) with feet,
1.70 in (4.32 cm) without feet
Width 19.0 in (48.26 cm) with ears,
17.03 in (43.25 cm) without ears
Depth 10.68 in (27.13 cm)
Weight 4.8 lbs (2.2 kg)
1. Specific models and protocols subject to verification; refer to the Crestron website or contact factory
for latest device support.
2. The latest software versions can be obtained from the Crestron website. Refer to the NOTE following
these footnotes.
3. Crestron 2-Series control systems include the AV2 and PRO2. Consult the latest Crestron Product
Catalog for a complete list of 2-Series control systems.
4. When loading VisionTools (VT) Pro-e files or firmware through the RS-232 port of the control
system, be sure that the baud rate is at 38400 (Cresnet speed) or lower. Otherwise, Toolbox may post
the “Transfer Failed” message.
NOTE: Crestron software and any files on the website are for authorized Crestron
dealers and Crestron Authorized Independent Programmers (CAIP) only. New users
may be required to register to obtain access to certain areas of the site (including the
FTP site).
Operations Guide – DOC. 6609A Isys ® G-Series Touchpanel Interface: TPS-GA-TPI • 5