Juniper Systems GNSS-RTK-628 - Manual (Page 4)

4 628 GNSS RTK Expansion Pack
L-band Positioning Mode
L-band equipped receivers allow you to achieve sub-
meter accuracy. In order to use this positioning mode, you
need an L-band-capable antenna and you must enable
L-band tracking to the OmniSTAR signal. A subscription
to OmniSTAR is required to use the OmniSTAR service.
For more information on L-band positioning, go to
NovAtel’s website at http://www.novatel.com. Select
Support | Knowledge and Learning | Application Notes.
Look for the application note called APN-051 Positioning
Modes of Operation.
OmniSTAR Subscription and Activation
Before you contact OmniSTAR to set up a subscription,
find out what the receiver’s OmniSTAR serial number is
(it is different from the NovAtel serial number.) It is a six
digit number in the range 100000 to 9999999. Refer to the
software operator’s manual for specific instructions to
obtain the OmniSTAR serial number.
Once you know what the serial number is, contact
OmniSTAR at 1-888-883-8476 or 713-785-5850. In order to
activate an OmniSTAR subscription, the receiver must be
powered and tracking an L-band satellite. When advised
by OmniSTAR of the appropriate satellite frequency
and data link rate for your location, follow the software
instructions to configure your receiver.
The latest frequencies can be obtained from the
OmniSTAR website at http://www.omnistar.com.