Remote control operations, Correct use of the remote control, Battery replacement – Philips DAT850 User Manual

Page 6: Name of parts and their functions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

REMOTE CONTROL OPERATIONS

Correct use of the remote control

• Press the button(s) while pointing the top of the remote control

unit at the remote sensor on the front panel of the main unit.

• The operable range is about 7 meters away from the main

unit. If operated at an angle, the range will be shorter.

• Do notallowdirectsunlightorstrong lightfrom afluorescent

light, etc. to strike the remote sensor, as far as possible.

Battery replacement

Open the battery compartment cover.

Insert two “R03” batteries.

Close the battery compartment cover.

MIUH --------------------- — S

1 1

. -

^i£St=3 caCafi)

l“l 1

■

1 1 m

_____

---------------------------

i=j"

CZ7

Name of parts and their functions

□ DISPLAY button
B RESET button
B REPEAT button
□ Numeric keys (“1” - “10”, “+10”)

Used to designate the desired tune directly.

START ID-WRITE button

Used to write a start ID.

B Tape operations buttons
B DIGITAL PEAK button

Used to recall or reset the maximum value stored in the digital
peak memory.

* Other control buttons have the same functions as those on

the front panel of the main unit.

Notes:

When the distance from which the remote control unit is

effective becomes shorter, the batteries are almost exhausted.
Replace the batteries with new ones.

Be sure to use two “R03" batteries in the remote control.

Incorrect use of batteries may cause corrosion or an explosion.
• Insert the batteries into the battery compartment with correct

• Do not use old and new batteries together.
• When the unit is not to be used for an extended period

of time, remove the batteries to prevent damage due to
corrosion.