Auto repeat, Playback using start id codes, Direct access playback – Philips DAT850 User Manual
Page 21: Àìti [t
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Auto repeat
This is used to piay back tunes you want to iisten again.
REPEAT
3
ALL: aii tunes are repeated
1: the current tune is repeated
Every time the REPEAT button is pressed, the foiiowing
indications are dispiayed.
[ÀÌTI
[T]
I—
RFPFAT—
I
l—RFPFAT—
I
ii:zz3 goes off
(Auto repeat function is canceiied.)
Playback using Start ID codes
To find the beginning of the previous tune..
1
indicator biinks
^
_
_^]
NEXT NO -----------
I I j—
When the PREViOUS button is pressed three times, the tape is
rewound to the beginning of the tune 2 before the current tune.
• Every time this is pressed, the start of the previous tune is
detected.
To find the beginning of the next tune..
indicator biinks
\
R
a
TI
.
'll 1
NEXT NO
• LI L
Direct access playback
Playback with program No. codes (can only be performed
using the remote control unit)
tune number buttons
When designating Program Nos. 1 to 10.
C±) C±1 C±]
C±l C±] C±]
□ l±l (±
O □(
Press the Program No. button corresponding to the number
of the tune.
• When designating tune No. 11 or higher..
Designate the required tune No. by pressing the +10 button
and a Program No. button. (When the +10 button is pressed
once, the “NEXT NO -1 ” is displayed.
example: when designating 24
♦10
*10
A
CZl
(ZIl
example: when designating 30
♦IQ
♦IQ
10
CZ] -► CZI
CD
• When the program No. code of the required tune is detected,
playback starts.
When the NEXT button is pressed twice, the tape is fast-for-
warded to the beginning of tune after next.
• Every time this is pressed, the start of the next tune is detected.
• When the Start ID code of the required tune is detected,
playback starts.
Notes:
1.
Tapes on which Program No. codes have not been marked
cannot be used for this operation if designating is performed
using the tune number buttons.
Tapes on which Start ID codes are not marked cannot be
used for this operation using the PREVIOUS/NEXT AUTO
SEARCH button.
2
.
When the ll PAUSE button is pressed while searching, the
deck enters the pause mode after locating the desired tune.
21