Philips DAT850 - Manual (Page 19)

AUTO ID EDIT operations
This function is to re-iocate Start ID codes which are being
marked slightly after the beginning of a tune by the Start ID
marking function.
Start ID codes are re-marked from 0.5 second before the
beginning of the tune.
With this function, the beginning of any tune can be located
more accurately.
1. Play back the tape and press the AUTO ID EDIT button at
the point from which the Start ID code is to be remarked.
AUTO ID EDIT The tape is stopped and is
then rewound to the point
6 second before.
The presence of a music signal is
judged at the -60 dB level. If a blank
space is not detected, the level at
which judgement is performed
becomes -50 dB or -40 dB.
PKM NO -------------------------- 7
fJTAfillO n 1 r n 1 , _______
U 1 o u o D
1^ j-JTJOCC
-1 -75 i H$ -1 -OJ 0 OS 1 see *1-10 POStnON
T
The point at which Start ID codes
are marked is adjusted in steps of
0.25 seconds
• The appropriate Start ID code marking point is..
signal level (tune)
------- ►---------------
the point where the signal level
rises to over -40 dB
no-signal level /^/st^ ID (already marked) This is
(below-40 dB) [ marked slightly after the beginning
of the tune
0.5 second
With the AUTO ID EDIT function,
the Start ID code is marked
0.5 second before the beginning of
the tune. This is a more appropriate
point.
2. When the appropriate point is detected, the ID POSITION
indicator blinks.
Example:
Indication when a signal of above -60 dB is recorded
^TAAT ID
NO
LI I
- P n J
O U O
1
1 TA«
Cir-
==.L=,=_ J--''««
-i *7$ 7 -ti *1 -0? 0 ”1-10 P0$1TICN
Indication of the most appropriate Indication of the recorded
marking point Start ID code
3. Press the START ID button.
START ID
• The START ID WRITE indicator lights and the Start ID and
Program No. codes are re-marked.
• When remarking is complete, the deck stops automatically.
• The appropriate marking point is also detected if the AUTO
ID EDIT button is pressed in the stop mode.
• The JUDGE indicator lights when the tune is found.
• To move the Start ID code marking point..
Press the PREVIOUS or NEXT button while the ID POSITION
indicator is blinking.
Every time this is pressed, the Start ID
code is moved backward in steps of
0.25 seconds, (up to 3.5 seconds)
c
1
Every time this is pressed, the Start ID
code is moved forward in steps of 0.25
seconds, (up to 1 second)
• When all of the JUDGE indicators light and “0” blinks in the
ID POSITION indicator.
This indicates that an appropriate marking point below -40 dB
cannot be found. Repeat operation
1. again.
Notes:
7, To cancel the AUTO ID EDIT function while it is operating,
press the ■ STOP or ► PLAY button.
2. When no tune is detected, the JUDGE indicator will not light.
3. When a tape on which A TIME codes have not been marked
is loaded, this function will not work.
4. When a section with a no-signal level (below -40 dB) cannot
be detected, mark the Start ID code referring to “marking
Start ID codes” on page 18.
s. Start ID codes are marked and shown by the ID POSITION
indicator in steps of 0.25 seconds. They could sometimes by
delayed if the AUTO ID EDIT button has been pressed.
19