Philips DAT850 - Manual (Page 20)

PLAYBACK
— Operate in numerical order. —
Before starting operation, set the TIMER switch to OFF.
Set the ON/OFF switch to ON. AUTO SEARCH buttons
r HILIPS REMOT« ««TROute cas.r*i TAJ>£ CCCK DAT8W
DAI
/
Set the TIMER switch to OFF.
0
®
0
©Press the ■/^STOP/OPEN-CLOSE button to open the
cassette tray. (See page 9.)
® Load a cassette with the window of the cassette facing up
and close the tray.
® Press the ► PLAY button. Playback will start.
• The sampling frequency is displayed in the display window.
• When a tape is played back to its end...
The auto rewind function rewinds the tape to its start at which
point it stops automatically.
• To stop playback in the middle of a tape..
Press the ■ STOP button. Press it again to open the cassette
tray.
• If the EMPHASIS indicator lights..
When the tape is reached a position where emphasis is applied,
high-frequency signals are deemphasized automatically by
the deemphasis circuit.
• If a tape recorded in 32k-LP mode is played back..
The 32 kHz and “LONG PLAY” indicators light in the display
window.
• To fast-forward or rewind the tape so you can hear the
speeded-up sound at a lower volume..
Press the REWIND or WIND button during playback. The
tape advances at 3 times normal speed.
c
1
To cue to a tune in the reverse
direction (review function) To cue to a tune in the forward
direction (cue function)
Notes:
1. If the End code is detected while the tape is being played
back or fast-forwarded, the tape stops automatically. Press
the REWIND button and rewind the tape.
2. If a new tape is played back, the tape is rewound to its start
within 10 seconds.
3. If the non-recorded section of a recorded tape is played back,
the tape is rewound to the end of the last tune within
10 seconds and stops automatically.
4. During high-speed playback, at the point where the mode
was changed in recording, sound might not be heard. In this
case, first perform normal playback and then set to the fast-
forward or rewind mode.
• When playing back a tape you have recorded yourself
(recorded on blank tape)
• When the cassette Is loaded..
• If A TIME codes have been marked on the tape, they are
detected and displayed in the display window.
• When a rewound tape is loaded, first (— 00:01) is displayed
and then the A TIME code is displayed.
• Program Nos. will be displayed when they are detected.
• When no Program No. is displayed in the PRGM No.
display:
Program No. codes are marked at the beginnings of tunes
together with Start ID codes. If the cassette is loaded/
unloaded in the middle of a tune and if a Program No. code
has not been marked at that point, no Program No. will appear
in the display. To display the Program No. in this case,
continue playback or set the deck to the fast-forward/rewind
mode so that the Program No. code is read out.
When the button is released, normal playback will resume.
20