Deleting sub codes, Marking program no. codes (renumbering), Marking start id codes – Philips DAT850 User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Deleting sub codes
• To delete Start ID (Program No.) codes
1
.
Play the tape and locate unnecessary Start ID codes.
START D
/
PRCMNO
n
J
-
n ■ n o ■ II n
u - u J - J L I
Start ID indicator
When an unnecessary Start ID is
marked at 9 minutes 30 seconds
2.
Press the Start ID erase button while START ID is displayed.
ERASE
PftGMNO
3
Erase indicator
• The tape is rewound and stops at the beginning of the
unnecessary Start ID code.
3.
When an unnecessary Start ID code has been erased, the
START ID indicator disappears and the tape stops
automatically.
• The Program No. is also erased at the same time if it has
been marked with the Start ID code.
• Deleting the End code
When recording starts after detecting the End code, the End
code will be erased automatically.
Notes:
1.
Be sure to mark Start ID codes leaving a gap of at least
18 seconds (36 seconds in the 32k-LP mode).
2
.
While a Start ID code is being marked, sound may be skipped
at the beginning and the end of the Start ID code; this is
not abnormal.
Marking Program No. codes (Renumbering)
• After marking Start ID codes is completed, insert Program
No. codes at the same points.
1.
Press the RENUMBER button in the stop mode.
END/RENUMBER
RENU^eSR
i
i
NEXT NO ^
L I U L 1 I
2.
The tape is rewound to its beginning and then Program No.
codes are marked at the points where Start ID codes are
detected, in sequence starting from 1.
R£NUS©ER P%MNO
n /recTNor;
^
When Program No. code 1 is renumbered..
Marking Start ID codes
• This is used to mark Start ID codes at the required points.
1.
Start playing the tape and find the point a Start ID code should
be marked.
Example:
When marking a Start ID code at 28 minutes 30 seconds..
PLAY
►
PRGMNO
A TIME-J -J - J . - ,
L I I L I ■ L L I -
_/
U
-t-
the position of 28 minutes 30 seconds
2.
Press the START ID button.
START ID
PRGMNO
START ID WRITE A TIME .
-f
U I U
■ C O •
D U
-A
• The numbers shown by the PRGM NO and NEXT NO
indicators are counted up.
3.
When the tape reaches its end, this operation is completed
and the tape is rewound to the start automatically.
• When the End code is detected, the deck stops at the beginning
of the End code.
Note:
Renumbering cannot be done during recording. Perform
renumbering in the stop mode.
Indication while marking the Start ID Recorded from an absolute time
code (when the Start ID code has 28 minutes 30 seconds
been encoded)
3.
When marking is finished, the “START ID WRITE” indicator
goes out.
Repeat the above procedures
l.
through
3.
to mark all required
Start ID codes.
of
18