Philips DVP620VR/17 - Manual (Page 8)

H9620UD_1_47,qx4 04.4.7 11:57 AM Page
8 Hookups (cont*d)
DVDA^CR to TV only
Simplest connection using only the supplied black RF coaxial cable
This connection will let you use the features of both the VCR and the DVD Player.
i Antenna or
Cable TV
signal
Antenna In Jack
(on back ofTV)
example only
Black RF
coaxial cable
(supplied)
Disconnect the antenna or Cable TV signal from your TV and con­
nect it to the ANT-IN (Antenna In) jack of your DVD/VCR.
Connect the supplied black RF coaxial cable to the ANTOUT
(Antenna Out) jack on the back of the DVD/VCR and to the
ANTENNA IN JACK on the TV. The ANTENNA IN jack on the TV may be
labelled TV IN,RF IN,75£2 (ohm), or ANT-IN. See yourTV owner’s manual for
assistance.
Plug in the power cords of the TV and the DVD/VCR.
Set yourTV to channel 3 or 4. The DVD/VCR’s output channel is 3 when
you purchase it. So, set yourTV to channel 3 when the DVD/VCR is new.
If you cannot use channel 3 at yourTV, you can change the DVD/VCR’s output
channel to channel 4.To do so, press the VCR button to put the DVD/VCR in
VCR mode.The VCR light will be on the front of the DVD/VCR. Insert a
videotape and press PLAY ► to start playback. During playback, press and
hold the (VCR) PLAY ► button on the front of the DVD/VCR for
three to five seconds. Each time you do this, the DVD/VCR’s output chan­
nel switches between 3 and 4, and the selected channel number appears on
the display panel. Change yourTV to channel 3 or 4 accordingly. (You cannot
change the DVD/VCR’s output channel while adjusting tracking manually. Press
STOP ■ to stop play and cancel manual tracking, then press PLAY ► to
resume playing and change the output channel.)
There is not a channel 3/4 switch on the DVD/VCR (as customary with most
VCRs).
You are ready to turn on the DVD/VCR. Go to page 17 before turn­
ing on the DVD/VCR.