32 videotape recording, To stop recording, press stop, Recording prevention – Philips DVP620VR/17 User Manual
Page 32: To allow recording, cover the hole with clear tape, Videotape recording, Helpful hints
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
H9620UD_1_47,qx4 04.4.7
11:57 AM Page 32
32 Videotape Recording
Read and follow the steps below to record a television program
onto a videotape.
♦ Before you begin, make sure the DVD/VCR is in VCR mode.
Press VCR so the VCR light appears on the front of the
DVD/VCR.
1
Turn on the TV.
% Insert a tape in the
# DVD/VCR.
Turn on the TV and set it to channel 3 or 4 or the
Video In channel. If you connected the DVD/VCR to the
TV using the supplied audio and video cables, select your
TV’s Video In channel. Details are on page 11.
If you connected the DVD/VCR to the TV using the sup
plied RF coaxial cable, choose channel 3 (or 4) at the TV.
Details are on pages 8-10.
Insert a tape with its record tab intact into the cas
sette compartment of the DVD/VCR. If tape playback
begins, press STOP ■.
Press SPEED until the desired tape speed (SP or
SLP) appears briefly on the screen. Details about tape
speed are on page 72.
Press SKIPM/CH ▲ or SKIP N /CH ▼ or the
Number buttons to select the TV channel to
record.
Press RECORD • to start recording. REC will appear
on the DVD/VCR’s display panel.
To pause the recording, press PAUSE 11 once. REC
will flash. To resume recording, press RECORD • or
press PAUSE 11 again. REC will reappear.
To stop recording, press STOP ■.
Recording Prevention
Video cassettes have record tabs to ensure that recordings are
not accidentally erased.
^ To prevent recording, break off the tab with a
j screwdriver.
To allow recording, cover the hole with clear tape.
Remove the
tab to prevent
recording.
Cover the
hole to allow
recording.
Helpful Hints
Other recording options are on
pages 33-39.
The VCR will record in a preset vol
ume.
Pause will switch to Stop after five
minutes to protect the VCR and
the tape from damage. When a
recording is paused, review the
pause time remaining with the ■
marks on the screen. Each ■
mark equals one minute remain
ing. During the last minute of
paused recording, the ■ mark will
flash.
If any menu is on the TV screen,
the RECORD • button on the
remote does not function. Press
CLEAR/RESET to remove the
menu.Then, press RECORD •. Or,
use the RECORD • button on the
front of the DVD/VCR.