Interlogix TruVision IP Camera Configuration Manual - Manual (Page 32)

2BChapter 3: Camera configuration
28 TruVision IP Camera Configuration Manual
3. Click Edit to set the arming schedule for the alarm input. See “To set up
motion detection” for more information.
4. Check the checkbox to select the linkage method.
5. Click Save to save changes.
To define alarm output:
1. In the Events folder, click the Alarm Output tab to open its window.
2. Select one alarm output channel from the Alarm Output drop-down list. You
can also set a name for the alarm output.
3. The delay time can be set to 5sec, 10sec, 30sec, 1min, 2min, 5min or 10min.
The delay time refers to the time duration that the alarm output remains in
effect after alarm occurs.
4. Click Edit to set the arming schedule for the alarm input. See “To set up
motion detection” for more information.
5. Click Save to save changes.
Snapshot parameters
You can configure scheduled snapshots and event-triggered snapshots. The
captured snapshots can be stored in the SD card (if supported) or the NAS
. You
can also upload the snapshots to an FTP server.
Figure 11: Snapshot menu