Interlogix TruVision IP Camera Configuration Manual - Manual (Page 19)

2BChapter 3: Camera configuration
TruVision IP Camera Configuration Manual 15
4. Click Save to save changes.
To define the PPPoE parameters:
1. In the Network folder, click the PPPoE tab to open its window.
2. Check Enable PPPoE to enable this feature.
3. Enter User Name, Password, and Confirm password for PPPoE access.
4. Click Save to save changes.
To define the SNMP parameters:
Note: Before setting the SNMP, please download the SNMP software and
manage to receive the camera information via the SNMP port. By setting the
Trap Address, the camera can send the alarm event and exception messages to
the surveillance center. The SNMP version you select should be the same as
that of the SNMP software.
1. In the Network folder, click the SNMP tab to open its window.
2. Select the corresponding version of SNMP: v1, v2c or v3.
3. Configure the SNMP settings. The configuration of the SNMP software should
be the same as the settings you configure here.
4. Click Save to save changes.
To define the 802.1x parameters:
Note: The switch or router to which the camera is connected must also support
the IEEE 802.1X standard, and a server must be configured. Please apply and
register a user name and password for 802.1X in the server.
1. In the Network folder, click the 802.1X tab to open its window.
2. Check Enable IEEE 802.1X to enable the feature.
3. Configure the 802.1X settings, including EAPOL version, user name, and
password. The EAPOL version must be identical with that of the router or the
switch.
4. Click Save to save changes.
To define the QoS parameters:
1. In the Network folder, click the QoS tab to open its window.
2. Configure the QoS settings, including Video / Audio DSCP, Event / Alarm
DSCP and Management DSCP. The valid value range of the DSCP is 0-63.
The bigger the DSCP value is the higher the priority is.
3. Click Save to save changes.