Interlogix Simon XT Installation Manual - Manual (Page 67)

Simon XT Installation Manual 61
To test communication with the central station:
1. Call the central station and tell the operator that you will be testing the
system.
2. Arm the system.
3. Test each of the wireless panic buttons and trip at least one sensor of each
type (fire, intrusion, etc.) to verify that the appropriate alarms are working
correctly.
4. When you finish testing the system, call the central station to verify that the
alarms were received.
Table 31: Sensor/user report codes
Arm or disarm from Reports as user
Panel or remote handheld touchpad 0
Key fob 1 to 40 (sensor number)
Panel auxiliary panic 41
Panel tamper 42
Panel police panic 43
Panel fire panic 44
Dealer access code 44
Installer access code 45
Master code 46
Access codes 1 to 8 47 to 54
Duress code 55
Two-way voice operation
For the central station operator to initiate an audio session:
1. After the panel has completed reporting the alarm, pick up the CS phone and
press the * button to start the audio session.
2. Press 1 or 0 to speak, 2 for VOX operation, and 3 or 6 to listen.
3. Press 99 to terminate the session.
Note: Panel voice announcements are silenced during AVM sessions. If the
operator does not terminate the session correctly, panel announcements may not
occur for up to 90 seconds after the operator hangs up.