IC Realtime 22X Optical / 10X Digital Zoom High Res Day/Night Speed Dome-24VAC (ICR2200DN) - Manual (Page 18)

Speed Dome Camera Instruction Manual 18/47
Preset
z Function Max. 127 positions can be stored as Preset position. The Preset number can be assigned
from 1 to 128, but 95 is reserved for starting OSD menu.
Camera characteristics (i.e. White Balance, Auto Exposure) can be set up independently
for each preset. Label should be blank and Relay Outputs should be set to OFF as default.
All characteristics can be set up in OSD menu.
z Set Preset [1~128]
z Run Preset [1~128]
z Delete Preset To delete Preset, use OSD menu.
Swing
z Function By using Swing function, you can make camera to move between 2 Preset positions
repeatedly. When swing function runs, camera moves from the preset assigned as the 1st
point to the preset assigned as the 2nd point in CW(Clockwise) direction. Then camera
moves from the preset assigned as the 2nd point to the preset assigned as the 1st point in
CCW(Counterclockwise) direction.
In case that the preset assigned as the 1st point is same as the preset assigned as the 2nd
point, camera turns on its axis by 360° in CW(Clockwise) direction and then it turns on its
axis by 360° in CCW(Counterclockwise) direction.
Speed can be set up from 1°/sec to 180°/sec.
z Set Swing To set Swing, use OSD menu.
z Run Swing Method 1) [Swing NO.+10]
Method 2) [Swing NO.+140]
ex) Run Swing 3 : [13]
ex) Run Swing 3 : [143]
z Delete Swing To delete Swing, use OSD menu.
1st Preset
2nd Preset
1
CW
Di
rec
tio
n
2
CC
W
Dir
ec
tio
n
OPERATION 3