Haltech F10 - Manual (Page 69)

64
F10A and F10A-8 only
13.2 The Output Options Page
To access the Output options page press Alt – O to open the options menu then scroll to the
Output Options menu item and press enter.
The Output Options page contains the controls for the F10 Idle Air Control and Closed Loop
Control options. Use the left and right arrow keys to highlight the function you wish to
modify, use the TAB key to cycle through the functions, and press ENTER to program the
change. A keystroke guide is available at the bottom of the screen.
(For more detail on Idle Control; Refer Chapter 14 Idle Speed Control, 65)
(For more detail on O2 Closed loop; Refer Chapter 15
Closed Loop Control, 69)
F10A and F10A-8 ONLY
13.3 The PWM Options Page
To access the PWM Options page press Alt – O to open the options menu then scroll to the
PWM Options menu item and press enter. Use the left and right arrow keys to highlight the
function you wish to modify, use the TAB key to cycle through the functions, and press
ENTER to program the change. A keystroke guide is available at the bottom of the screen.
(For more detail on PWM options; Refer Chapter 16
PWM Outputs, 72)
13.4 Enabling Options
Every option has an Enable flag at the top of its window. Toggling this flag allows you to
“enable” and “disable” the output. The remaining control for an option that is disabled will
not be changed. When a map is loaded from disk output functions are automatically disabled.
After loading a map, return to the Output Options Page and check the functions you want
enabled.