beautypg.com

GTCO SummaSketch FX - Users Guide User Manual

Page 6

background image

SummaSketch FX 6


4. Power up the SummaSketch FX. Press the on/off switch to turn the tablet on.

(Pressing it again turns the tablet off). The SummaSketch FX tablet is now ready for
use. The power/prox light will illuminate when the tablet is on and blink if the
transducer is not within 1/2” of the tablet surface.

Chapter 2: Caring for the SummaSketch FX Tablet

Caring the for the SummaSketch FX

Below are basic guidelines for the care and maintenance of the SummaSketch FX tablet.

Turn the tablet and computer off and unplug them both before cleaning. Also,
unplug the power supply.

To clean the SummaSketch FX tablet, wipe with a damp, lint-free cloth and a mild
detergent solution. Do not use abrasive cleaners on the tablet surface.

Never disassemble the SummaSketch FX tablet. There are no user-serviceable parts
inside.

When you turn off the computer, also turn off the tablet.

Never scratch or mar the tablet surface.

Never immerse the SummaSketch tablet or accessories in liquid.

Do not trace through metal or metallized paper. Do not use metal objects, such as
metal or metal-edged rulers on the tablet.

Cursor Care

The transparent part of the cursor that encases the crosshair is called the paddle. Protect
the paddle. Do not scratch, mar or separate. To clean, wipe with a lint-free cloth
dampened with water. Do not use any other type of cleaner or solvent. Never immerse
the cursor in liquid.

Stylus Care

To clean, wipe with a lint-free cloth dampened with water. Do not use any type of cleaner
or solvent. Never immerse the stylus in liquid.

The stylus comes with two different refill types – one standard and a spring version. In
order to change the refill, carefully twist the nose about 30 degrees counterclockwise and
remove. You will then be able to remove the refill by pulling it straight out. After putting in
the new refill, reinstall the nose noting that the flat part is slanted 30 degrees to the top
side (button side) before pushing in and twisting 30 degrees clockwise.