GTCO SummaSketch FX - Users Guide - Manual (Page 37)

SummaSketch FX 37
Part IV: Appendices
Appendix A: What to do if a Problem Arises
Problem Solutions
The power/prox light is not on. 1. Check that the power switch is in the ON
position.
2. Check that the power supply cable is plugged
into the interface cable connector.
3. Check that the power supply is plugged into a
working electrical outlet.
4. Check that the I/O cable phone connector is
plugged into the proper location on the
tablet.
The screen cursor does not move
when I move the stylus/cursor. 1. Check that the application is configured for
the proper stylus/cursor.
2. Run the test program to see if you get
coordinates.
3. Press a stylus/cursor button to ensure the
stylus/cursor is active.
4. Reset the tablet and restart the application.
5. In cordless mode, be sure that the batteries
are oriented properly and that the battery
contacts are clean.
The buttons on the stylus/cursor do
not work. 1. Check that the application is configured for
the proper tablet driver.