GTCO SummaSketch FX - Users Guide - Manual (Page 26)

SummaSketch FX 26
NOTE: If you do not define the active area within approximately seven seconds, the
crosshair changes back to an arrow and it is necessary to click inside the tracking area box
again.
To define the active area, position the transducer on the lower left corner of the active area
that you wish to define and click. Then position the cursor on the upper right corner of the
active area. Click on TEST to test the next active area. The new active area does not take
effect until you click on TEST or OK.
NOTE: To aid in defining the active area, cut a piece of scrap paper to the size of the active
area you wish to define and position it on the tablet and secure with tape.