GTCO SummaSketch FX - Users Guide - Manual (Page 5)

SummaSketch FX 5
B. Insert two (2) 393 batteries and replace the battery hatch. Care should be exercised
when inserting the batteries to be sure that the battery contacts are not
overstressed (bent too far back). Be sure to observe the proper orientation
(polarity) of the batteries.
C. Replace the battery hatch by sliding it back on until fully seated. The cordless stylus
is now ready for use with the SummaSketch FX tablet. Proceed to step four of the
installation instructions.
NOTE: The cordless stylus has a special energy saving feature designed to extend the life of
the batteries. After approximately 5-10 minutes of non-use, the cursor will automatically
shut itself off. To reactivate the cursor, simply press a button.
Using the Stylus Corded
To prepare either the three-button pressure sensitive stylus for corded use:
A. Remove the battery hatch as described above.
B. Remove the batteries if the transducer was previously used cordless. Carefully plug
the connector of the corded stylus cable into the socket located in the battery
compartment. Please note do not force the connector into the socket. The plug and
socket are keyed and fit together in one direction only. If one way does not work,
try the other.
C. Replace the cordless battery hatch with the corded battery hatch.
D. Plug the stylus cable into the top right socket on the SummaSketch FX tablet. The
corded stylus is now ready for use with the SummaSketch FX tablet. Proceed to step
four of the installation instructions.