Great Planes Tracer 46 Kit - GPMA0400 - Manual (Page 21)

❏
10. Cut openings in the bottom sheeting for the
aileron servos.
❏
11. Use two 1/16" x 3" x 30" balsa sheets to sheet the
top center section of the wing.
❏
12. Using the 1/16" x 1/4" x 30" balsa sticks, cut, fit and glue
cap strips to all of the exposed ribs, both top and bottom.
❏
13. Cut a 1" diameter hole out of the top center sheeting
for the aileron servo leads as shown on the plan. Hint: A
quarter makes a nice template.
❏
14. Sand the TE sheeting flush with the TE.
❏
15. Drill two 1/4" holes, at the punch marks, in the die-
cut 1/8" ply forward dowel support.
❏
16. Trim the ends of the shaped LE so the forward dowel
support will fit flush against the inboard ends of the LE and
tight against the retract servo tray.
❏
17. Position the 1/4" x 3-1/2" basswood wing dowels in
place lying against the retract servo tray, then epoxy the
forward dowel support in place. DO NOT GLUE the dowels
at this time.
❏
18. Remove the dowels and drill 1/4" holes through the
1/16" balsa shear webs.
❏
19. Round one end of each dowel. Epoxy the dowels in
place with the rounded end forward so that the dowel
protrudes as shown on the plan.
21