Canon 50 - Manual (Page 109)

109
Edi
ting
E
2. Press the MENU button and select [VCR SETUP]. Select [AV DV/ ]
(OPTURA60) or [AV DV] (OPTURA50), set it to [ON] and press the
MENU button.
3. Selecting the still image quality:
Press the FUNC. button. Select the still image quality symbol followed
by a setting option and press the FUNC. button.
Selecting the movie size:
Press the FUNC. button. Select the movie size symbol followed by a
setting option and press the FUNC. menu.
4. Connected device: Load a recorded cassette and play back the tape.
When recording a still image:
5. Press the PHOTO button halfway when the scene you wish to record
appears.
• The still image, remaining image capacity and other information appear.
• When you press the PHOTO button on the wireless controller, recording starts
immediately.
6. Press the PHOTO button fully.
The card access indicator flashes.
When recording a movie:
5. Press the start/stop button when the scene you wish to record
appears.
Pressing the start/stop button again stops recording.
 Headphones cannot be used during analog line-in recording.
 Depending on the signal sent from the connected device, dubbing may not work
properly (e.g. signals that include copyright protective signals or anomalous
signals such as ghost signals).
 We recommend powering the camcorder from a household power source.
 An image recorded from an image in widescreen mode will be vertically
compressed.
 The data code of the image will reflect the date and time it has been recorded
on the memory card.