Philips CCX092AT - Manual (Page 8)

8 Turning On the TV/YCR
Before you turn on the TV/VCR, make sure there are batteries in
the remote control (details are on page five) and the TV/VCR is
hooked up correctly (details are on pages six - seven).
The instructions on this page work only when you turn on the
TV/VCR for the first time.
I
Press the POWER button. The TV/VCR will come on and the
language select display screen shown below will appear.
r
SELECT LANGUAGE
I ENGUSH
2 ESPAÑOL
ON
MAKE SELECTION OR
PF^ EXtTTO CONTINUE
2
Press the Number I button to select English on-screen
displays or press the Number 2 button to select Spanish
on-screen displays.
3
Press the STATUS/EXIT button.The channel program display
screen shown below will appear.
Oa^^ECГANTB^INft OR CAa£
TOTVCR
THEN PRESS+
TO END PRESS EXIT
4
Press the F.FWD/+ button to begin automatic channel
programming. The TV/VCR will place all of the channels you
receive into its memory, so when you scan through channels using
the CHANNEL Up/Down buttons, you’ll only scan through chan­
nels that you receive.When channels are programmed, CHAN­
NELS ARE SET will appear on-screen briefly.Then the TV/VCR will
go to the lowest channel programmed.
(If you try to program channels when there is no antenna or cable
connected to the TV/VCR, programming will appear to take place,
but eventually a NO TV SIGNALS ... message will appear on­
screen. Connect an antenna or cable to the TV/VCR, then try
again.You may need to follow the steps on pages nine - 11
instead.)
5
Now, you may use the CHANNEL Up/Down buttons or the
Number buttons on the remote control to select aTV/VCR chan­
nel. Use the VOLUME Up/Down buttons to adjust the sound.
O
cpcp CD S
3
'SMJTB _
O O O Oi
O C D O O ^
PHILIPS
Helpful Hints
if you do not see any on-screen dis­
plays when you turn on the TV/VCR,
check your hook-ups^ then try again.
If you still do not see any on-screen
displays, follow the steps on pages
nine - 11 to select a language and
program channels.
To skip this feature and play a tape
immediately, insert a tape with its
record tab removed. Playback will
begin. Or, to skip step 2, press the
STATUS/EXIT button be^re pro­
ceeding. All on-screen displays will be
in English.To skip step 4, press the
STATUS/EXIT button before pro­
ceeding. Channels will not be pro­
grammed, and CHANNELS NOT
SET will appear on-screen briefly.
You cannot program channels If you
are using a Cable Box.
line Input mode will always be
stored in theTV/VCR’s memoiy as
channel OO.When you select chan­
nel 00,AfV IN will appear on-screen
briefly. Press the CHANNEL
Up/Down buttons or Number but­
tons to select another channel.