Philips CCX092AT - Manual (Page 10)

10 Channel Memory
Although theTVA/^CR may automatically memorize the channels
you receive when you turn it on for the first time, you may pro­
gram channels again. Follow the steps below to program channels.
I
Press the MENU button to display the pop up menu.
' to ADJUST PRESS+/-
► INPUT
EXIT
PRIM. SETUP
VCR PROGRAM
VCR SETUP
oymoN
j CABLE 1
2
Press the PIJ\Y/A button or the STOP/V button to select
INPUT. Press the REW(ind)/- button or the F.FWD/+ but­
ton until ANTENNA or CABLE (whichever you have)
appears to the right of the pop up menu.
3
Press the STOP/T button repeatedly to select PRIM.
SETUP, then press the F.FWD/+ button.
PRIMARY SETUP
1 SELECT LANGUAGE
2 ALTO PROGRAMMING
3 ADD/DELETE CHANNEL
4 CH. MEMORY REVIEW
5 VOLUME BAR [ON]
6 SET CLOCK
TO SELECT PRESS NUMBER
TO END PRESS EXIT
4
Press the Number 2 button to select AUTO PROGRAM­
MING. AUTO PROGRAMMING MEMORIZED CH....will appear
on-screen.TheTV/VCR will place all of the channels you can
receive into its memory.
5
Wait for a few minutes. When programming is complete,
CHANNELS ARE SET will appear on-screen.Then the program­
ming of the lowest channel number placed in theTV/VCR’s memo­
ry will appear on-screen. Now, when you press the CHANNEL
Up/Down buttons, you will scan only through channels you
receive.
5 Wait for theTV/VCR to pro­
gram channels.
Hefpfijl Hfnts
Line Input mode will always be
stored in the TV/VCRi memory as
channel 00. You cannot delete it To
exit fine input mode, press the
CHANNEL Up/Down buttons or the
Number buttons to select another
channel.
You cannot program channels when
the TV/VCR is on channel 00 {AfV
INPUT v/ill be selected at INPUT at
step 2). SeleaANTENNA or CABLE
at step 2.