I hookingupthetyivcr – Philips CCX092AT User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
i HookingUpTheTYIVCR
I
Hook up yourTY/VCR using one of the connections shown.
A.
Hooking Up Your TV/VCR With a
Cable Signal or Outdoor Antenna
B
Hooking Up Your TV/VCR With a
Cable Box
To view any channel, set the TV/VCR to the
Cable Box output channel (channel 03 or 04).
Then, select channels at the Cable Box.
Connect the Cable signal to the IN
jack on the Cable Box.
Connect an RF coaxial cable (75-
ohm, not supplied) to the OUT
jack on the Cable Box and to the
ANT(enna) Jack on die TV/VCR.
c.
Hooking UpYour TV/VCR With an
Indoor Antenna
To instali a rod antenna (supplied), push the
stem of the antenna into the antenna hole on
die top of the TV/VCR. Connect the antenna
wire to the ANT(enna) jack on the back of
the TV/VCR as shown. Extend the antenna
and adjust its length, direction, and angle for
the clearest picture.