Philips CCX092AT - Manual (Page 7)

Hooking
up
The TV/VCR (cont’dj 7
2
Connect the AC cord to the AC 120V jack on
the back of the TV/VCR. Plug in the TV/VCR.
3
Before you turn on the TV/VCR, go to page eight.
Mobile Connections
Usually, the supplied indoor rod antenna provides adequate reception. But when you want to watch TV
outdoors or in a vehicle, use a mobile antenna (not supplied) or an indoor dipole antenna (not supplied)
and a car battery cord (supplied) to get good reception.
Mobile Antenna
I
Mobile Antenna Hookup
Refer to the instructions with your mobile
antenna to make a connection similar to this
one.
2
Car Battery Cord Hookup
Make sure your vehicle has a 13.2-voit, nega­
tive ground electrical system. Connect one
end of the car battery cord to the DC 13.2V
jack on the back of the TV/VCR, Then con-
nea the other end of the car battery cord to
the cigarette lighter in your vehicle.
Heipfui Hints
Do not watch TV while driving.
Use only the supplied car biittery cord. Using another cord could damage the TV/VCR
Alflke sure the cigarette lighter jack is free of ashes and other dehr/s.
Aloke sure you push the car battery cord’s plug completely into the dgarette lighter.
Always unplug the car hotter/ cord from the dgareUe lighter before you unplug it from the TV/VCR
You must disconnect the car battery cord from the TV/VCR before you can use standard electrical power.
If you use the TV/VCR with the vehic/e's engine off recharge the vehic/e's battery every four hours. Unplug the
car battery cord from the dgarette lighter when you finish using the TV/VCR
When you use theV/IVCR with a car battery cord, noise may appear on the TV/VCR screen.
P/eose do not use this TV/VCR under high temperature conditions.
Before connecting an antenna or coaxial cable to theANT(enna) jack, make sure the pin is not bent If the pin
is bent stro/ghten it os illustrated, then connect it to the ANTfenna) Jack,
Crooked Pin Straight Pin