Futaba 6XHS - Manual (Page 52)

H ELICOPTER S ETUP I NSTRUCTIONS
The following example shows how the T6XAs/XHs may be programmed for a helicopter model.
Your model’s settings will be dependent on the setup and linkages. Ask an experienced pilot for
assistance.
Receiver
Switch
Harness
To Battery
Charging
Jack
Aileron Servo
(CH1)
Optional
Gyro
System
Elevator Servo
(CH2)
Throttle Servo
(CH3)
Rudder Servo
(CH4)
Pitch Servo
(CH6)
7
6
5
4
3
2
1
B
Dual Conversion
FP-R127DF
FM 7CHANNEL
RECIVER
1. Memory Selection
Use the model select function [MODL] to
select an available model memory.
Choose Helicopter settings from within
the parameter menu.
CAUTION: if you select a new type of
model, you’ll lose all the data already in the
model memory.
2. Hook up controls.
In the helicopter, install each servo and
hook up the aileron, elevator, throttle, rudder,
and pitch pushrods to the servos in accordance
with the model’s instructions or plans.
3. Plug In Servos (see figure
above).
CH1................Aileron
CH2................Elevator
CH3................Throttle
CH4................Rudder
CH5................spare (or Gyro Sensitivity)
CH6................Pitch
4. Set Servo Throw Direction
– 47 –
Check the proper direction of throw for
each servo. Use the reversing function [ REV ]