Futaba 6XHS User Manual
Page 49
move the trim tab for that channel until the triangle disappears — this is the nominal neutral
trim. Repeat for the other channel numbers. When you've done all three, hit the DATA
INPUT keys simultaneously, then center the trim tabs. You've initialized the trim.
MODL — Model Select
Your T6XAs/XHs system can store up to six independent sets of model data in its
memory. The Model Select (
MODL
) function allows you to choose from any of the six sets of
model data.
There are several ways to keep track of which model is in each memory. You may attach
a small piece of white tape to the transmitter front and write the model's name along with the
model setup number, or you may use a notebook, or label the model with its memory number
prominently near its on-off switch inside the fuselage.
Choosing another model memory to load
1. Press on the
MODE
buttons until
MODL
appears on the menu.
2. Select the desired model number by pressing the (+) or (–) keys. At this
time, the selected model number will blink on and off.
3. Press
the
CURSOR
key, and the word SET? appears blinking on and off in
the display.
4. Press both the (+) and (–)
DATA INPUT
keys at the same time. A beep-beep sound indicates
that the selected memory is now the active one.
– 44 –