Futaba 6XHS User Manual

Page 47

3. If you are sure you wish to choose a new model type, press both

DATA INPUT

keys

simultaneously again. This resets the model type and erases the memory. The model type

letters will stop flashing to indicate the changed model type.

MOD

—

Modulation Select (PARA sub-function)

The Modulation menu is used to select the PCM or PPM mode of transmission, to match the

receiver being used (PCM = Pulse Code Modulation, and PPM = Pulse Position Modulation,

also called FM for Frequency Modulation). The T6XA/XH system ships with a PPM receiver,

but if you also will be using a PCM receiver, you should select the PCM mode for that receiver.

Note that you have to turn your transmitter on and off before a modulation change becomes

effective.

Changing your transmitter’s modulation

1. Press on the

MODE

buttons until the

MOD

window appears.

2. To select PCM modulation, press the (+)

DATA INPUT

key. The letter

displayed. To select PPM modulation, press the (–)

DATA INPUT

key.

The letter

is displayed.

3. To get the transmitter to operate in the new mode, switch transmitter power off and then on.

The small indicator will indicate the new mode, either PPM or PCM.

COPY — Copy Model

The

COPY

function is used to copy the current model data into another model memory.

This function is handy to use to start a new model that’s similar to one you have already

programmed, and is also handy for copying the current model data into another model memory

as a backup.

Copying from one model memory to another

1. Press on the

MODE

buttons until the

COPY

window appears.

2. The source model memory (the memory that will be duplicated)

is the current one. To select your destination model number,

press the (+) or (–)

DATA INPUT

keys. The selected destination memory number will flash on

and off, and a small triangle will appear under it.

Source

Destination

3. Press

the

CURSOR

key, and the word SET? appears blinking on and off in the display. If you

do not wish to reset the data, press the

CURSOR

key or a

MODE

key or return to the regular

window.

– 42 –

This manual is related to the following products:

6XAS