Futaba 3VCS - Manual (Page 74)

75
Functions
(Initial screen)
Use the or
button to select the
menu screen.
Press the button.
Use the or
button to select the
function.
Press the button.
Calling the setup screen
* When the direct call button is set,
the setup screen is also called by the
following method:
MENU SELECT
DIRECT SEL
Press the and
button simulataneously.
Press the button set
at this function.
* Calling from menu screen
(Initial screen)
MENU
Model Select/MDL-SEL
Use this function to call a new model number, or to change a set model number, to set
new model data.
The T3VCS transmitter can store the model data for ten R/C cars. The CAMPac-16K
(Option) can store model data for ten more models.
The model numbers are 01 to 10 at the transmitter and 11 to 20 at the CAMPac-16K.
When the CAMPac-16K is not installed, model numbers 11 to 20 are not displayed.
Calling model memories of different modulation modes (HRS, PCM, or PPM)
After the new model is called, signals are still output in the old model modulation
mode until the transmitter power is turned off. Before using the new modulation
mode, turn the power off and on.
CAMPac -16K (Option)
For the transmitter to use the CAMPac-16K, it must be initialized when the power is
turned on for the first time. If "INITIALIZE" is displayed on the screen when the
power is turned on, press the (+) button. This automatically initializes the transmitter.
This operation is unnecessary thereafter.
Inserting and removing the Data Pac
Before inserting and removing the CAMPac-16K, turn off the power switch. If the
power is turned off when a model number (11 to 20) in the Data Pac is selected and is
turned back on after the CAMPac-16K has been removed, "SELECT ERROR" will
be displayed and model 01 will be forcibly selected.
*Current model No. and model name
Model Select/MDL-SEL