Futaba 3VCS - Manual (Page 58)

59
Functions
Timer/TIMER
LAP TIMER
LAP TIMER function
- The LAP TIMER can memorize each lap time of each switch operation. (99 laps)
- The race time can be set. Switch operation after the set time by alarm has elapsed
automatically stops the timer.. Prealarm can also be set. The passage of time is
announced by sounding of a buzzer ([Pee] sound) each minute after starting.
Alarm: Generates a [Pee] sound at the set time.
Prealarm: Starts sounding the set time (second) before
the alarm. (PeePeePee, PeePeePee, -----)
- The first start operation can be linked with the throttle
stick.
(LAP TIMER operation)
- When lap timer is selected, the number of laps (LAP) and the lap memory No. (No.)
and current lap time (TIME) are displayed on the setup screen.
Number of laps (LAP): Counts up each time the switch is pressed after starting. The
numbers blink for 3 seconds after the switch was pressed. To prevent erroneous
counting, switch operation is not accepted during this period..
Lap memory No. (No.): Each lap time is memorized in a lap memory. The lap times
are written sequentially from the number after the preceding data. After lap memory
"No. 100", the lap No. returns to "No. 1".
The lap time data memorized in the lap memory can be checked at the lap list (See
page 65)
screen.
Lap time (TIME) : During the first 3seconds, the last lap time is displayed and then
the current lamp time is displayed. At starting, "0" is displayed for 3 seconds.