Futaba 3VCS User Manual

Page 35

Functions

Setup item switching
- Use the (DN) or (UP) button to switch
the setup item.

100%

Throttle (EPA) adjustment
(Preparation)
- Before setting the throttle steering angle, set the throttle
ATL dial (initial setup: BT2) to the maximum steering
angle position 100%.
- Select setup item "TH-FWD" and make the following ad-
justments:

1 Throttle (forward side) adjustment

Turnthe throttle stick fully to the high side and use
the (+) or (-) buttons to adjust the throttle angle.
However, when using an FET amp, set to 100%.

2 Throttle (brake side/reverse side) adjustment

Turn the throttle stick fully to the brake side and use
the (+) or (-) buttons to adjust the throttle angle.
However, when using an FET amp, set to 100%.

3 When adjusting the throttle angle of another channel

immediately after this, see the adjustment method
for that channel. When ending adjustment, return to
the initial screen by pressing the (END) button
three times.

Setup item switching
- Use the (DN) or (UP) buttons to
switch the setup item.
- Others switch the setup item (direc-
tion) linked with the throttle trigger.

End point adjuster/EPA (All channels)

3rd channel servo (EPA) adjustment
(Preparation)
- Select setup item "3C-UP" and make the following adjust-
ments:

1 3rd channel servo (up side) adjustment

Set the 3rd channel dial fully to the up side (+ side)
and use the (+) or (-) buttons to adjust the steering
angle.

2 3rd channel servo (down side) adjustment

Press the (DN) button and select setup item "3C-
DWN" and set the 3rd channel dial fully to the down
side (-) and use the (+) or (-) buttons to adjust the
steering angle.

3 When adjusting the steering angle of another chan-

nel immediately after this, see the adjustment
method for that channel. When ending adjustment,
return to the initial screen by pressing the (END)
button 3 times.