Flintec FDT-B - Manual (Page 16)

FLINTEC
Document Date Code Rev. Page
FDT – VERSION A/B – TECH. -REFERENCE MANUAL 05.04.99 FDT.RM 2 16 of 23
6. FUNCTION MENU
The function menu enables the selection of a number of software programs indirectly. Press key A.
Display shows Fn 00 . Key in the function code desired (using NUMSCROLL entry procedure).
NUMSCROLL EDIT
T = MOVE ONE DIGIT TO THE RIGHT (CYCLIC)
I = INCREMENT FLASHING DIGIT
P = ACCEPT DISPLAYED NUMBER
The corresponding program will be activated.To exit the function selection, press P
while Fn 00 is displayed. The following functions are available.
Fn 01
-30 SELECT FAD ADDRESS
When P is pressed FAD xx is displayed briefly if the selection is within the range of
FADs programmed. The default setting will be re-installed after power up.
Fn 31 EDIT SETPOINTS
Display shows SetP 1 briefly, then the existing setpoint value key in the desired value
(using NUMSCROLL entry procedure).
Display shows SetP 2 briefly, then the existing setpoint value key in the desired value
(using NUMSCROLL entry procedure).
Fn 32 EDIT & STORE SETPOINTS IN EEPROM
Identical to Fn 31. In addition the setpoints will be automatically saved in non volatile memory.
Fn 33 AUTOTUNE
Searches all baudrates and data bits/ parity combination until communication is established
with a FAD. The FDT will search all FAD addressess (starting from A) with each combination
of baudrate / data bits. It will exit when the first FAD is found. Communication setup data
of this FAD may be observed with Fn 46. If no FAD is responding the routine is executed
until power down or O is pressed.
Fn 35 SET DATE – TIME – SERIAL Nr. (Enabled only if SETUP 1.6 = 1)
-Display shows: DDMMYY or MMDDYY (depends on setup 1.4)
DD=Day, MM=Month, YY=Year. Use NUMSCROLL to edit the date.
-Display shows: HHmmSS. HH=Hour, mm=minutes, SS=Seconds. Edit the time.
-Display shows: nnnnn, the print serial number. Edit the print number.
The program ends and returns to weight display.
Fn 40 PIN CHANGE
Used to change the current Personal Identification Number that enables access to the
calibration procedure. (The unit is factory set so that the PIN is not active ie 000000).
The display shows Pin 0 briefly then 000000. Key in the old pin and P.
The display shows Pin 1 if the pin was correct else the unit is reset. Key in the new Pin and P .
The display shows Pin 2. Key in the same Pin for validation and P . The new pin is stored and
the display shows PASS briefly. If the two entries are not the same, FAIL is displayed briefly
and the program returns with the old pin remaining in memory.
WARNING : Make sure you do not loose the code entered. If the code is lost the unit must
be returned to the factory to initialise the Pin and a fee will be charged.
Fn 41
DOWNLOAD CUSTOM PRINT FORMAT . 1
The display shows For 1 indicating that it is ready to receive format 1.
Begin the transmission. When the transmission ends press P . the display shows Prn 1
briefly when the format is saved in non volatile memory. A max of 512 bytes may be stored.
If more characters are received they will be lost.