Procedure of configuration parameters programming, Level 1, Level 2 – EVCO EK825AP7 User Manual
Page 10: How to leave the procedure
10
PROCEDURE OF CONFIGURATION PARAMETERS PROGRAMMING
The configuration parameters programming can be done during the status "STOP" only, if there is not a corrupted memory data alarm.
There are two Levels of configuration (Level 2 is protected by password):
Level 1
Keep pushed
T 8
and
T 9
at the same time for 4 seconds at least: on the indicator DY 1 appear the
parameter "PA".
Push
T 8
or
T 9
to select the parameter to modify at Level 1.
Keep pushed
T 10
and
T 8
or
T 9
to modify the selected parameter: after the modify release the key T 10 as last.
Level 2
From Level 1 push
T 8
or
T 9
to select the parameter "PA".
Keep pushed
T 10
and
T 8
or
T 9
to set "-19": after the modify release the key T 10 as last.
Keep pushed
T 8
and
T 9
at the same time for 4 seconds at least: on the indicator DY 1 appear the first
parameter of Level 2.
Push
T 8
or
T 9
to select the parameter to modify at Level 2.
Keep pushed
T 10
and
T 8
or
T 9
to modify the selected parameter: after the modify release the key T 10 as last.
How to leave the PROCEDURE
Keep pushed
T 8
and
T 9
at the same time for 4 seconds at least or wait 50 seconds without operate on
the keyboard (time-out exit) or stop and restart the instrument after about 1
second from the last modify.