Chapter 1. introduction, Installation and configuration overview, Locating the latest software and documentation – Comtrol IOLM 4-EIP User Manual
Page 5
IO-Link Master 4-EIP User Guide: 2000582 Rev. A
Chapter 1. Introduction - 5
Chapter 1. Introduction
This document provides installation, configuration, and embedded web interface information for the IO-Link
Master 4-EIP. The embedded web interface provides a platform so that you can easily configure, review
diagnostic pages, and access advanced features, such as: uploading the latest IO-Link Master images or
applications, and set up user accounts with different user levels and passwords.
Detailed information interface specifications are located in the following IO-Link Master Reference Manuals:
•
IO-Link Master EtherNet/IP Reference Manual
•
IO-Link Master Modbus/TCP Reference Manual
1.1. Installation and Configuration Overview
IO-Link Master installation includes the following procedures.
1.
Install the IO-Link Master hardware (
).
2.
If necessary, configure the IP address using PortVision DX or the embedded web page (
).
3.
Configure the IO-Link ports using the embedded web page (
4.
Connect the IO-Link devices (
).
1.2. Locating the Latest Software and Documentation
You can use the links in this table to locate the latest images, application subassemblies, utilities, and
documentation. For detailed information about images or application subassemblies and updating IO-Link
Master, see
4.3.2. Updating Application Subassemblies
Latest Images
Application Base
FPGA
U-Boot Bootloader
System uImage (Primary/Backup)
Latest Application Subassemblies
Application Manager
Configuration Manager
Discovery Protocol
EtherNet/IP