Comtrol IOLM 4-EIP - Manual (Page 11)

IO-Link Master 4-EIP User Guide: 2000582 Rev. A Chapter 2. Hardware Installation - 11
Connecting the Power
- Steady red indicates duplicate IP address on the network
• EIP 1/2 should be steady green indicating that the link is up if both connectors are connected.
If the LEDs indicate that you ready for configuration, go to Chapter 3. Initial Configuration on Page 13.
If the LEDs do not meet the above conditions, you can refer to the 2.5. IO-Link Master LEDs table on Page 12
and if necessary, refer to
Chapter 8. Troubleshooting and Technical Support on Page 57.
Note: Power connectors must have an approved cable or protective cover attached to the port guarantee IP67
compliance.